|
francis xavier l,j. pratap kumar,v.j. leo,d. jairajfrancis xavier l,
"fatigue test on cost effective aluminium metal matrix composite prepared from discarded toner powder and coconut shell ash particles",
journal of thin films, coating science technology and application,2019,vol: 5
|
|
francis xavier l,paramasivam sureshfrancis xavier l,
"drilling studies on the prepared aluminum metal matrix composite from wet grinder stone dust particles",
science and engineering of composite materials,2017,vol: 25
|
|
francis xavier l,p. sureshfrancis xavier l,
"studies on dry sliding wear behavior of aluminium metal matrix composite prepared from discarded waste particles",
international journal of advanced engineering technology,2016,vol: 07
|
|
francis xavier l,paramasivam sureshfrancis xavier l,
"wear behavior of aluminium metal matrix composite prepared from industrial waste",
the scientific world journal,2016,vol: 2016
|
|
francis xavier l,p. suresh,r. balaragavendheran,p. yeshwanth kumar,s. deepakfrancis xavier l,
"studies on the influence of drilling cycle on the surface roughness of the drilled holes",
arpn journal of engineering and applied sciences,2016,vol: 11
|
|
francis xavier l,d.elangovan,s.r.devadasan,s.nelson gnanaraj,s. praveen kumarfrancis xavier l,
"optimization of the surface roughness of the drilled holes on low cost reinforced aluminium metal matrix composite",
international journal of applied engineering research,2015,vol: 10
|
|
francis xavier l,d.elangovan,s.r.devadasan,p.yeshwanth kumar,m.bharathfrancis xavier l,
"investigation on the burr formation during drilling through holes for achieving low cost reinforced aluminium metal matrix composite",
international journal of applied engineering research,2015,vol: 10
|
|
francis xavier l,p. suresh,j. saravanakumar,yuvaraj,yeswanthfrancis xavier l,
"drilling of aluminium metal matrix composite using automatic coolant system",
international journal of applied engineering research,,2015,vol: 10
|
|
francis xavier l,
"design and fabrication of miniaturized gear pump by rapid prototyping techniques",
international journal of applied engineering research,2015,vol: 10
|
